Cisco Meraki Go GR10-HW-UK Indoor Access Point Wifi

Product Information

Verify the gateway or another mesh repeater that has a route to the gateway and is within range of the mesh repeater. This can be done by moving them closer together with a line of sight and away from physical obstructions. Monitor and manage your account from anywhere, including setting usage limits and scheduling when your guest WiFi is available Meraki Go Onboarding No image available If you have not yet added hardware to your account and configured it, you will need to go through onboarding. ii) high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices.

Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies pour un environnement non con trôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre la source de rayonnement et votre corps. Using a client machine (e.g., a laptop), connect to the AP wirelessly (by associating to any SSID broadcast by the AP) or over a wired connection.On the L2TP PPP Options modal, select only the PAPauthentication method. Be sure the other authentication methods are de-selected. All other options can remain as the default. Select OKto continue. Configure separate WiFi networks for your staff, guests, and point-of-sale (POS) system to better protect your business and increase PCI compliance

Meraki Go Accessories No image available This guide houses articles regarding modules and accessories which work with Meraki Go devices. Troubleshooting A collection of articles to help troubleshoot common problems on Meraki Go hardware. Network problems come in varying forms and degrees of difficulty. This guide acts as a collection of all Meraki Go troubleshooting articles. See the table below for a listing of all troubleshooting documents. Seamlessly go between managing your network from your computer to the mobile app based on your preferenceStatic IPs are assigned using the local web server on each AP. The following procedure describes how to set the static IP: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment is for indoor use only and the PoE device is considered unlikely to connect to an Ethernet network with outside plant routing, including campus environments. IEEE 802.11b or 802.11g operation of this product in the USA is firmware-limited to channels 1 through 11.